Mustang GT V8-4.6L SOHC VIN X (1998)
4. Install new O-ring seal in groove of push rod. Grease recess at push rod end with Silicone Brake Caliper Grease and Dielectric Compound
D7AZ-19A331-A (in Canada, Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A.
5. Position strut pin into rear disc brake caliper and in recess of parking brake lever. Insert push rod into push rod bore of rear disc brake caliper.
Make sure pin is positioned correctly between shaft recess and recess at end of push rod. Place key plate over push rod so locating nib fits into
drilled locating hole in rear disc brake caliper. Install flat washer, push rod spring and spring retainer in sequence.
Outer Spacer
6. Insert outer spacer into piston bore.
NOTE: Tools used in Steps 6 through 9 are part of Caliper Spring Compressor Set 206-SO27.
