Mustang GT V8-4.6L SOHC VIN X (1998)
NOTE: Make sure one slot in piston face is positioned so it will engage with nib on rear brake lining.
12. Install rear disc brake caliper assembly.
Removal and Installation
REMOVAL
1. Raise vehicle on a hoist.
2. Remove wheel and tire assembly.
3. Remove rear wheel brake hose from rear disc brake caliper.
4. Remove retaining clip from parking brake rear cable and conduit at rear disc brake caliper.
5. Release tension from parking brake rear cable and conduit and disengage parking brake rear cable and conduit end from parking brake lever.
6. Hold disc brake caliper locating pin hex-heads with open-end wrench and remove rear brake pin retainers.
7. Lift rear disc brake caliper assembly away from rear disc support bracket.