Mustang GT V8-4.6L SOHC VIN X (1998)
NOTE: Do not pinch or damage boot material.
8. Remove disc brake caliper locating pins and boots from rear disc support bracket.
INSTALLATION
1. Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (in Canada, Motorcraft WA-10) or equivalent meeting Ford
specification ESE-M1C171-A to inside of locating pin boots and to disc brake caliper locating pins.
2. Position disc brake caliper locating pins and boots in rear disc support bracket.
3. Position rear disc brake caliper assembly and rear disc support bracket. Make sure rear brake linings and disc brake pad anti-rattle clips are
installed correctly.
4. Apply a drop of Threadlock and Sealer EOAZ-19554-AA or equivalent meeting Ford specification WSK-M2G315-A5 to rear brake pin retainer
threads. Install rear brake pin retainers. Tighten to 31-35 Nm (23-26 ft. lbs.) while holding disc brake caliper locating pins with an open-end
wrench.
5. Attach end of parking brake rear cable and conduit to parking brake lever. Install cable retaining clip on rear disc brake caliper assembly.
