Mustang GT V8-4.6L SOHC VIN X (1998)
Crankshaft Pulley Keyway Silicone Gasket Sealant Application Locations
23. Apply Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6 in keyway of crankshaft pulley
as shown.
NOTE: Prior to applying sealer, clean sealing surfaces with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification
WSE-M5B392-A, to remove all residues that may interfere with the sealer's ability to adhere.
24. Position crankshaft pulley on crankshaft. Make sure crankshaft key and keyway are aligned.
25. Using Crankshaft Damper Replacer 303-102 (T74P-6316-B), install crankshaft pulley.
26. Install crankshaft pulley bolt and crankshaft pulley retaining washer. Tighten in four steps:
a. Tighten to 90 Nm (66 ft. lbs.).
b. Loosen one complete turn.
c. Tighten to 50 Nm (36 ft. lbs.).
d. Tighten an additional 90 degrees.
27. Install oil pan with new oil pan gasket.
28. Position power steering pump on engine and install four retaining bolts. Tighten to 20-30 Nm (15-22 ft. lbs.).
29. Lower vehicle.
30. Connect engine control sensor extension wire to the A/C clutch, crankshaft position sensor and evaporative emission canister purge valves.
31. Position and connect 42-pin engine harness connector and 8-pin connector.
32. Position A/C line and install retaining nut.
33. Install positive crankcase ventilation valve in RH valve cover.
34. Connect vent hose to evaporative emission canister purge valve.
35. Install water pump pulley and tighten bolts to 20-30 Nm (15-22 ft. lbs.).
36. Position RH ignition coil bracket, ignition wires and ignition wire separators onto mounting studs.
37. Install three nuts retaining ignition coil bracket to engine front cover. Tighten to 20-30 Nm (15-22 ft. lbs.).
38. Install LH ignition coil bracket. Tighten nuts to 20-30 Nm (15-22 ft. lbs.).
39. Install LH ignition coil and ignition wires as an assembly.
