Mustang GT V8-4.6L SOHC VIN X (1998)
26. Install oil pan with new oil pan gasket as an assembly. Tighten bolts in sequence shown to 20 Nm (14 ft. lbs.) then tighten bolts in sequence an
additional 60 degrees.
27. Install crankshaft pulley using Crankshaft Damper Replacer 303-102 (T74P-6316-B).
NOTE:
-
Prior to applying sealer, clean sealing surfaces with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification
WSE-M5B392-A, to remove all residues that may interfere with the sealer's ability to adhere.
-
Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6 must be applied to crankshaft
keyway prior to installing crankshaft pulley.
28. Install crankshaft pulley bolt and crankshaft pulley retaining washer. Tighten in four steps:
a. Tighten to 90 Nm (66 ft. lbs.).
b. Loosen one complete turn.
c. Tighten to 50 Nm (36 ft. lbs.).
d. Tighten an additional 90 degrees.
