Mustang GT V8-4.6L SOHC VIN X (1998)
NOTE:
-
Prior to applying sealer, clean sealing surfaces with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification
WSE-M5B392-A, to remove all residues that may interfere with the sealer's ability to adhere.
-
Install valve cover and retainers no more than four minutes after applying sealer.
4. Install valve cover gasket, valve cover, bolts and studs bolts. Tighten stud bolts and bolts to 8-12 Nm (71-106 in. lbs.) no later than four minutes
after applying sealer.
5. Install ignition wire separators on studs and connect ignition wires to spark plugs.
6. Position and connect fuel charging wiring to the electronic variable orifice sensor and oil pressure sensor.
7. Position and connect speed control actuator cable.
8. Install air cleaner outlet tube.
9. Connect battery ground cable.
10. Start engine and check for leaks.