Mustang GT V8-4.6L SOHC VIN X (1998)
Front Crankshaft Seal: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Release drive belt tensioner and remove drive belt.
3. Raise vehicle on hoist.
4. Remove crankshaft pulley bolt and crankshaft pulley retaining washer from crankshaft.
5. Install Crankshaft Damper Remover 303-009 (T58P-6316-D) on crankshaft pulley and Dull crankshaft pulley from crankshaft.
6. Using Front Cover Seal Remover 303-107 (T74P-6700-A), remove crankshaft front seal.
INSTALLATION
1. Lubricate seal bore in engine front cover and seal lip with clean engine oil.
2. Using Crankshaft Seal Replacer/Cover Aligner 303-335 (T88T-6701-A), install crankshaft front seal.
3. Using Crankshaft Damper Replacer 303-102 (T74P-6316-B), install crankshaft pulley.
