Mustang GT V8-4.6L SOHC VIN X (1998)
5. Install studs and bolts retaining engine front cover to engine in location as shown in illustration. Tighten to 20-30 Nm (15-22 ft. lbs.) in no more
than four minutes after applying sealant.
6. Connect fuel charging wiring to the crankshaft position sensor.
7. Install RH ignition coil bracket and ignition wires as an assembly. Tighten nuts to 20-30 Nm (15-22 ft. lbs.).
8. Install LH ignition coil bracket. Tighten nuts to 20-30 Nm (15-22 ft. lbs.).
9. Install LH ignition coil and ignition wires as an assembly.
10. Position and install power steering oil reservoir.
11. Connect engine control sensor extension wire to both ignition coils and camshaft position sensors.
12. Install valve covers.
13. Raise vehicle on hoist.