Mustang GT V8-4.6L SOHC VIN X (1998)
Control Assembly: Service and Repair
Climate Control Assembly Switch Knobs
REMOVAL
1. To remove any of the three control knobs on the heater control, grasp and pull rearward.
NOTE: Do not pry the knob off its shaft. Damage to the surface of the heater control assembly bezel may result.
2. If the D-shaped spring clip which sits inside the back end of knob remains on shaft when knob is pulled off, remove it with needlenose pliers and
install on knob.
INSTALLATION
1. To install knob, align its keyed surface with mating surface on shaft. Press knob forward until fully seated in heater control.
