Mustang GT V8-4.6L SOHC VIN X (1998)
Refrigerant Pressure Sensor / Switch: Service and Repair
A/C Cycling Switch
REMOVAL
1. Disconnect the wire harness connector from the A/C cycling switch.
2. Unscrew the A/C cycling switch from the top of the suction accumulator/drier.
INSTALLATION
1. Lubricate the O-ring seal on the suction accumulator/drier nipple with clean Motorcraft YN-12b refrigerant oil or equivalent meeting Ford
specification WSH-M1C231-B.
2. Screw the A/C cycling switch on the suction accumulator/drier nipple and hand-tighten.
3. Connect the wire connector to the A/C cycling switch.
4. Check the A/C cycling switch installation for refrigerant leaks.
5. Check the system for proper operation.