Mustang GT V8-4.6L SOHC VIN X (1998)
Drive Belt: Service and Repair
CAUTION: Make sure drive belt is properly installed before starting engine, otherwise drive belt damage will occur.
NOTE:
-
Minor cracks in the V-grooved portion of the drive belt are considered normal and acceptable. If the drive belt has chunks missing from the
ribs, it should be replaced.
-
When installing drive belts on pulley, make sure that all V-grooves make proper contact with pulleys.
Conditions requiring drive belt replacement are excessive wear, rib chunk-out, severe glazing, frayed cords and other concerns. Replace any drive belt
exhibiting one of these conditions.
REMOVAL
1. Lift or rotate automatic drive belt tensioner away from drive belt.
WARNING: DO NOT ALLOW DRIVE BELT TENSIONER TO SNAP BACK, AS DAMAGE TO DRIVE BELT TENSIONER OR
PERSONAL INJURY COULD RESULT.
NOTE: The drive belt tensioner positive stop must be removed prior to the drive belt.
2. Remove old drive belt.
INSTALLATION
Drive belt installation
1. Follow removal procedure in reverse order. Make sure that all V-grooves make proper contact with the pulley as shown.
CAUTION: Incorrect drive belt installation will cause drive belt failure.
2. Install drive belt tensioner positive stop and retaining nuts. Tighten nuts to 20-30 Nm (15-22 ft. lbs.).
