Mustang GT V8-4.6L SOHC VIN X (1998)
6. Remove retaining screw, then remove crankshaft position sensor.
INSTALLATION
1. Make sure the crankshaft position sensor mounting surface is clean and that the crankshaft position sensor O-ring is in proper location on
crankshaft position sensor.
2. Position crankshaft position sensor and install retaining screw. Tighten to 8-12 Nm (71-106 lb-in).
CAUTION: Do not overtighten crankshaft position sensor retaining screw or damage to the sensor may occur.
3. Install A/C compressor. Evacuate and recharge A/C system.
4. Properly route engine control sensor wiring and connect electrical connectors to A/C compressor and crankshaft position sensor.
5. Lower vehicle.
6. Install serpentine drive belt.
7. Connect battery ground cable.