Mustang GT V8-4.6L SOHC VIN X (1998)
REMOVAL
1. Remove rear seat cushion and rear seat back.
2. Remove rear quarter trim panel.
3. Remove rear safety belt retractor and tongue retaining bolt.
4. Remove safety belt anchor-to-front floorpan bolt.
5. Remove rear seat shoulder belt retractor cover.
6. Remove rear safety belt retractor and tongue.
INSTALLATION
1. Position rear safety belt retractor and tongue. Make sure safety belt webbing is not twisted. If it is, remove the twist.
2. Install safety belt anchor-to-front floor pan bolt. Tighten bolt to 34-46 N.m (25-33 Lb-Ft).
3. Install safety belt retractor and tongue retaining bolt. Tighten bolt to 34-46 N.m (25-33 Lb-Ft).
4. Install rear seat shoulder belt retractor cover.
5. Install rear quarter trim panel.
6. Install rear seat cushion and rear seat back.
7. Check restraint system for proper operation and perform Functional Test Procedure.
Convertible
