Mustang GT V8-4.6L SOHC VIN X (1998)
Seat Belt Retractor: Service and Repair
Front Seat Belt, Retractor and Tongue
Coupe
Seat Belt Bolt Bit
SPECIAL SERVICE TOOL(S) REQUIRED
NOTE: Safety Belt Bolt Bit (T77L-2100-A) (No. 50 TORX (R) should be used for removal and installation of the safety belt bolts on all safety belt
assemblies.
REMOVAL
1. Remove safety belt anchor-to-sill bolt and rubber washer.
2. Slip finger behind D-ring cover and push bottom of cover toward center of vehicle to dislodge. Lift up to remove cover and remove retaining bolt.
3. Remove rear seat cushion and rear seat back cushions.
4. Remove the upper and lower quarter trim panels and unthread safety belt from slot in quarter trim panel.
5. Remove front retractor retaining bolt.
