Mustang GT V8-4.6L SOHC VIN X (1998)
INSTALLATION
1. Position the BPP switch so the U-shaped side is nearest the brake pedal and directly over/under the pin. Then slide the BPP switch up/down,
trapping the master cylinder push rod and blade bushing between the stoplight switch sideplates. Push brake pedal position switch and push rod
assembly firmly toward brake pedal arm. Assemble outside white plastic washer to pin and install hairpin retainer to trap whole assembly.
CAUTION: Do not substitute other types of pin retainers. Replace only with production hairpin retainer.
2. Assemble the wire harness connector to the brake pedal position and install the wires in the retaining clip.
NOTE: The main wiring harness must have sufficient length to travel with brake pedal position during full stroke of brake pedal. If wire length is
insufficient, reroute harness or service as required.
3. Check the BPP for proper operation.
