Mustang GT V8-4.6L SOHC VIN X (1998)
Windshield Washer Switch: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Remove steering column shroud retaining screws and remove upper and lower steering column shrouds.
3. Disconnect the wiring connectors.
4. Remove two self-tapping screws retaining the multi-function switch to the steering column assembly. Disengage the switch from the steering
column assembly.
INSTALLATION
1. Align multi-function switch mounting holes with corresponding holes in the steering column assembly. Install two self-tapping screws making sure
to start the screws in the previously tapped holes. Tighten to 2-3 Nm (18-26 inch lbs.).
2. Connect the electrical connectors.
3. Install upper and lower steering column shrouds with the screws. Tighten to 0.6-1.13 Nm (6-10 inch lbs.).
4. Connect battery ground cable.
5. Check steering column assembly and multi-function switch for proper operation.
