Mustang GT V8-4.6L SOHC VIN X (1998)
6.
If the positive tensioner stop was not installed on the vehicle, remove the three (3) fasteners that mount the automatic belt tensioner. Retain the nut.
Discard the tensioner, belt guide and both bolts (Figure 4).
7.
Install the new steel Tensioner (F8ZZ-6B209-BA) using one (1) existing stud and two (2) new Studs (N807336-S2) (Figure 5). Torque the studs
and nuts to 20-30 N.m (15-22 lb-ft).
8.
Install a new FEAD Belt (F8AZ-8620-AA).
9.
Install the Tensioner Positive Stop (F7ZZ-19A439-AC) onto the two (2) studs that mount the tensioner (Figure 5). Fasten the stop bracket with two
(2) Nuts (N804178-S309). Torque the nuts to 20-30 N.m (15-22 lb-ft).