Mustang GT V8-4.6L SOHC VIN X (1998)
procedure.
Remove the EPC solenoid bracket retaining bolt. Remove the EPC solenoid bracket.
11. NOTE: Use a shop cloth to protect pan-to-case surface.
Remove manual lever shaft retaining pin.
12. Using a 13/16-inch open-end wrench on the inner nut and a 12 mm wrench on the manual control lever shaft flats, loosen the inner nut.
Slide manual control lever partially out of the case to complete removal of the inner nut from manual control lever.
13. Slide manual control lever out of case. Position manual valve detent lever so that EPC solenoid can be removed. Remove EPC solenoid connector
by grasping connector body and pulling. Remove EPC solenoid by sliding it out of the case bore.
INSTALLATION
