Mustang GT V8-4.6L SOHC VIN X (1998)
Clutch pressure plate should be held downward as the clearance is checked.
If the clearance is not within specification, install the correct size retaining ring and recheck the clearance. Selective retaining rings are available in
the following thicknesses:
8. NOTE: Scarf-cut seals must be installed with mating surfaces as shown.
Install two scarf-cut seals on the forward clutch cylinder and shaft if original seals are damaged or missing.
The clearance should be:
^
1.27-2.26 mm (0.50-0.089 inch)
9. Install No. 3 forward clutch hub front bearing. Install forward clutch hub into forward clutch cylinder and shaft. Make sure forward clutch hub is
against No. 3 forward clutch hub front bearing.
