Mustang GT V8-4.6L SOHC VIN X (1998)
Clutch Disc: Testing and Inspection
CAUTION: Do not use cleaners with petroleum base and do NOT immerse the clutch disc in ANY solvents or damage to component may result.
CAUTION: Replace the clutch disc assembly if any of these conditions are present. Springs loose enough to rattle will not cause noise when the
vehicle is operating. Be especially careful when installing a new clutch disc to avoid dropping or contaminating it with oil or grease.
Inspect the clutch disc facings for oil or grease. Eliminate the source of any oil or grease before replacing the clutch disc.
Any excessive amount of lubricant on the pilot bearing or clutch release hub and bearing will find its way to the clutch disc facings. Too much
lubricant in the transmission or a plugged transmission vent will force the transmission lubricant out the input shaft and onto the clutch disc facings.
Also, engine rear main bearing oil seal leaks or oil leaks from the flywheel retaining bolts can contaminate the clutch disc.
Inspect the clutch disc for worn or loose facings, distortion, loose rivets at the hub, and for broken springs.
