Mustang GT V8-4.6L SOHC VIN X (1998)
Place the upper arm rear bushing remover tool in position and pull out rear suspension arm bushing
INSTALLATION
1. Using Suspension Bushing Service Set 204-SO30 (T78P-5638-A), install rear suspension arm bushing into bushing ear of rear axle housing
2. Place the rear suspension arm and bushing into the bracket of body side rail. Insert a new, upper arm-to-frame pivot bolt and nut with nut facing
outboard. Do not tighten at this time.
3. Raise the suspension with hoist until upper arm-to-axle pivot hole is in position with hole in rear suspension arm bushing. Install a new pivot bolt
and nut with nut facing inboard. Do not tighten at this time.
4. Raise the suspension to curb height. Tighten the front upper arm bolt to 95-130 Nm (70-95 ft. lbs.).
