Mustang GT V8-4.6L SOHC VIN X (1998)
Pinion Bearing: Specifications
Minimum Torque Required to Tighten Pinion Flange Nut to Obtain Correct Pinion Bearing [1]:
Preload ............................................................................................................................................................................................... 190 Nm (140 ft.lbs.)
Pinion Bearing Preload-(Collapsible Spacer) [2]:
Used Bearings ......................................................................................................................................................................... 0.9-1.5 Nm (8-14 inch lbs.)
[1] If pinion bearing preload exceeds specification before this torque is obtained, install a new collapsible spacer.
[2] With oil seal.
