Mustang GT V8-4.6L SOHC VIN X (1998)
Drive/Propeller Shaft: Service and Repair
Disassembly and Assembly
DISASSEMBLY
Special Tool
1. CAUTION: Under no circumstance is the driveshaft assembly to be clamped in the jaws of a vise or similar holding fixture. Denting or localized
fracture may result, causing driveshaft failure during vehicle operation.
Place driveshaft on a suitable work bench. Be careful not to damage the tube.
2. Prior to disassembly, mark the positions of the driveshaft components relative to the driveshaft tube. All components must be reassembled in the
same relationship to maintain proper balance.
3. Clamp U-Joint Tool 205-086 (T74P-4635-C) in vise.
4. Remove the four snap rings that retain the bearing cups.
5. Position the driveshaft slip yoke in U-Joint Tool 205-086 (T74P-4635-C) and press out bearing cup. If bearing cup cannot be pressed all the way
out of the driveshaft slip yoke, remove it with vise grip or channel-lock pliers.
6. Reposition the driveshaft slip yoke in U-Joint Tool 205-086 (T74P-4635-C) 180° to press on the spider and remove the remaining bearing cup
