Mustang GT V8-4.6L SOHC VIN X (1998)
6. Set Analog/Digital Switch on TR-E Cable to Digital.
CAUTION: Route all cables away from heat sources to prevent damage to cables during testing.
Use the transmission tester extender cable when running tests with the transmission on the vehicle.
7. Turn large dial to DIGITAL TR SENSOR TEST.
8. CAUTION: For resistance checks, be sure that the tester selector switch is set to the TR SENSOR TEST position or damage to the ohmmeter
may result.
Plug transmission tester power cable into cigar lighter socket.
All LEDs should light for a short period and then turn off. This is the Tester's internal circuit check.
SENSOR TEST
CAUTION: Be sure that the DIGITAL 12 pin sensor cable connector (black) is used. If the wrong connection is made or the slide switch is in the
wrong position, the LEDs on the TR cable will give false or no response during testing. This will cause the replacement of good parts.
1. Place transmission range selector lever into PARK.
2. Make sure that the "E" cable ANALOG/DIGITAL switch is set to DIGITAL.
3. Move the transmission range selector lever through all ranges.
4. Monitor the LEDs, located on the "E" cable, in each gear position. The LED should illuminate RED for the appropriate range selected.
5. If the LED for the applicable gear range position fails to illuminate RED or if it lights for a position other than the gear selected:
^
Verify test cable connections at sensor and tester.
^
Verify transmission shift linkage for proper adjustment.
^
Verify digital TR sensor for proper adjustment.
^
Retest.
6. If the sensor still fails to illuminate the LED RED for the selected gear range or indicates incorrect gear position, replace it.
SWITCH TESTS-PARK/NEUTRAL, BACKUP LAMP AND OPTIONAL CIRCUITS
