Mustang GT V8-4.6L SOHC VIN X (1998)
NOTE: Allow a minimum of five minutes for glass primer to dry.
9. Apply an even bead of urethane adhesive meeting Ford specification WSB-M2G316-B around entire sheet metal flange on top of existing bead of
urethane. The bead should be triangular in shape, 16 mm (0.625 inch) high and 8 mm (0.33 inch) at base.
NOTE:
-
Leave a door window slightly open until adhesive is cured.
-
Apply new urethane on top of existing material on pinch weld.
10. Install back window assembly onto vehicle, taking care to align marks on glass to body. This must be done before adhesive skins over.
CAUTION: When replacing urethane installed glass parts, do not drive the vehicle until the urethane has cured. At 21°C (70°F) and 50 percent
relative humidity, adequate cure time is typically 24 hours (less at higher temperatures and higher humidities). See detailed instructions provided
by the urethane manufacturer. Inadequate or improper curing may adversely affect the retention of the back window glass.
11. Install luggage compartment weatherstrip.
12. Reconnect rear window defroster wires, if equipped.
13. Remove spacer and install headliner.
14. Install front and rear roof trim panels.
15. Install rear quarter interior trim panel.
16. Check installation for air and water leaks in urethane seal.
CAUTION: Use only urethane for service of air and water leaks in urethane-set back windows, or deterioration of urethane may result.
