Mustang GT V8-4.6L SOHC VIN X (1998)
4. Using a clean wool applicator, wipe inside glass edge with Urethane Glass Cleaner or equivalent meeting Ford specification WSB-M5B280-C2,
25 mm (1 inch) wide along top, sides and bottom. Wipe off glass prep and repeat application.
NOTE: Wipe off Urethane Glass Cleaner or equivalent meeting Ford specification WSB-M5B280-C2 immediately after application because it
flash dries. Prep application must be applied twice.
5. Properly align windshield glass to body.
a. Place windshield glass into opening. Center it top and bottom, side-to-side (adjust lower glass stops if necessary).
b. Using masking tape or crayon, make alignment marks at points on four sides of both glass and window opening.
6. Remove windshield glass from vehicle and place it back on work table.
7. Thoroughly shake and stir Urethane Glass Primer or equivalent meeting Ford specification WSB-M2G314-B to make sure of uniform pigment
mixing.
8. Using a clean wool applicator, apply primer to inside glass edge 25 mm (1 inch) wide along top, sides and bottom.
NOTE: Allow a minimum of five minutes for glass primer to dry.
9. Install foam tape meeting Ford specification ESB-M3G137-A or equivalent along top edge of cowl pinch weld.
10. Apply an even bead of urethane adhesive meeting Ford specification WSB-M2G316-B around entire sheet metal pinch weld on top of existing
bead of urethane. The bead should be triangular in shape, 16 mm (0.625 inch) high and 8 mm (0.33 inch) at base.
NOTE:
-
Leave a door window slightly open until adhesive is cured.
-
Apply new urethane on top of existing material on pinch weld.
11. Install windshield assembly onto vehicle, taking care to align marks on glass to marks on body. This must be done before adhesive skins over.
12. Remove spacer from headliner and install sun visors and retainers.
13. Install inside rear view mirror.