Mustang GT V8-4.6L SOHC VIN X (1998)
The turn signal switch is incorporated into the multi-function switch.
The turn signal lever is located on the LH side of the upper steering column assembly.
-
To operate the turn signal(s), the ignition switch must be in the RUN position.
-
To indicate a normal full turn, move the turn signal lever to the end-of-travel position for the turn desired.
-
The lever will remain in position without effort until-the turn is completed, at which time the turn indicator cancel cam will automatically cancel
the turn signal.
The turn signal system also has a lane change feature. Operate the lane change feature as follows:
-
Move and hold the turn signal lever to the first stop position when changing lanes.
-
When the lane maneuver is completed, release the lever and it will return to its normal position.
The turn signal lever also operates the headlamp dimmer switch and the flash-to-pass feature.
NOTE: Excessive force used to hold the turn signal lever in the flash-to-pass function followed by quick release may result in incorrect headlamp
dimmer selection of high beam. The driver must be cautioned to avoid this condition.
-
Select high beam by pushing the turn signal lever away from the driver to the stop.
-
Release the lever to maintain high beams.
-
Select low beam by pulling the turn signal lever toward the driver from the high beam position.
-
Release the lever to maintain low beams.
-
To operate the flash-to-pass feature, pull the lever gently toward the driver.
-
When the lever is released, it will return to the low beam position.
-
If driving without headlamps on, use of the flash-to-pass feature will turn on the high beams until the turn signal lever is released.
-
If the headlamps are turned on, the low and high beams will be on until the lever is released.