ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Campaign - Keyless Entry System Transmitters|Page 5956 > < Campaign - Keyless Entry System Transmitters
Page 2
background image

Mystique. On Contour and Mystique models only the horn will sound and the exterior lights will flash.

 
4.

Press any button on the remote keyless entry transmitter. All doors will lock then unlock to verify transmitter has been programmed. The horn will
sound and the exterior lights will flash on the Contour and Mystique.

NOTE:  

Programming in the first transmitter will erase all other previously programmed transmitters. All transmitters that are to operate with the
vehicle (up to four transmitters) must be programmed during Steps 4 and 5.

 
5.

Repeat Step 4 for any additional remote transmitters to be reprogrammed.

 
6.

Turn ignition switch OFF. All doors should lock then unlock. On Contour and Mystique models the horn will sound and the exterior lights will
flash.

 
7.

Remove short (Econoline models only).

 
8.

Install any trim previously removed.

 
9.

Verify transmitter operation.

RKE Programming Connector Location
The Two-Pin RKE Programming Connector Is Located;
 
Taurus/Sable Wagons - behind the left side trim panel inside the cargo area. Remove the trim panel for access to the connector.
 
Taurus/Sable Sedans - Under the left side of the package tray.
 
Contour/Mystique - under the right side of the instrument panel, behind right side of glove compartment. Reach up behind the glove compartment for
access to the connector.
 
Probe - in the trunk behind the subwoofer on the right side of the vehicle. Remove the subwoofer (if so equipped) for access to the connector.
 
Mark VIII, Crown Victoria, Grand Marquis and Town Car - behind the glove compartment. Open the glove compartment, compress the sides to allow it
to fully open and let it hang for access to the connector.
 
F-Series and Bronco - under the drivers side of the instrument panel above the drivers right foot area.
 
Mustang - in the trunk behind the left side trim panel. Loosen the lining board (convertibles only) and the rear and left side trim covers to gain access to
the connector.
 
Thunderbird/Cougar - behind the left side trim panel inside the trunk. Remove the trim panel for access to the connector.
 
Explorer - behind the left quarter utility compartment access panel. Remove the panel for access to the connector.
 
Windstar - behind and to the right of the glove compartment, compress the sides to allow it to fully open and let it hang for access to the connector.
 
Econoline - under the instrument panel to the left of the steering column.
 
Continental - under the right side of the instrument panel near the glove compartment. Remove the panel from beneath the instrument panel for access to
the connector.
 
For further information regarding connector location and color-coding refer to the appropriate Electrical Vacuum and Troubleshooting Manual (EVTM).

Dealer Letter

To:  
All Ford and Lincoln-Mercury Dealers

Subject:
Owner Notification Program 95B79 - Remote Keyless Entry System Transmitters - Special "Mail-In" Service Program

OASIS
NO

Owner List
NO

Campaign - Keyless Entry System Transmitters|Page 5956 > < Campaign - Keyless Entry System Transmitters