Probe V6-153 2.5L DOHC (1994)
6.
Lay roof opening frame on flat surface with motor facing down.
7.
Refer to Figure 1 for Steps 7a through 7d.
a.
Apply foam tape (approximately 170 mm long x 30 mm wide x 4 mm thick) to both outer edges of rain channel (Figure 1, View A).
b.
Apply felt tape (approximately 20 mm long x 10 mm wide x 0.5 mm thick) to both lifter stoppers contact surfaces (Figure 1, View B).
c.
Apply cloth tape (approximately 20 mm wide) to sliding roof panel opening on all four (4) sides of drive unit.
d.
Using a 15/64" drill bit, enlarge the RH sliding roof panel drive locator hole and lubricate locator hole with teflon grease or equivalent.
8.
Turn roof opening frame over so that the motor is facing up.
