Probe V6-153 2.5L DOHC (1994)
10.
Apply foam tape (approximately 30 mm long x 30 mm wide x 4 mm thick) to backside of headliner's styrofoam blocks (Figure 3).
11.
Apply two (2) pieces of foam tape (approximately 20 mm long x 30 mm wide x 4 mm thick) to sliding panel backside at locator flange (Figure 4).
12.
Reinstall roof opening frame by referring to the Service Manual, Section 01-17.
NOTE:
MAKE SURE THAT THE DRIVE MOTOR CABLE GUIDES DO NOT CONTACT THE ROOF PANEL WHEN INSTALLED (FIGURE 1).
13.
Reinstall sliding roof panel by referring to the Service Manual, Section 01-17.
14.
Adjust roof panel by referring to the Service Manual, Section 01-17.
15.
Reinstall headliner by referring to the Service Manual, Section 01-05.
16.
Reconnect negative battery cable.
17.
Road test, checking for squeak rattle and windnoise from the sliding roof panel area.
