Probe V6-153 2.5L DOHC (1994)
Brake Pad: Service and Repair
Removal and Installation
1. If the rear brake shoe and lining are to be reused, inspect the rear brake shoe and lining and measure the thickness.
2. Install the rear disc brake rotor, if removed.
NOTE: If the rear brake shoe and lining are reused, they must be installed in their original positions.
3. Install the rear brake shoe and lining retaining clips. Position the shims on the rear brake shoe and lining. Position the rear brake shoe and lining
into the rear disc brake caliper anchor plate.
4. Install the anti-rattle spring onto the rear brake shoe and lining.
5. Install the rear disc brake caliper onto the guide pin. Pivot the rear disc brake caliper over the rear disc brake caliper anchor plate.
Brake Caliper Bolt
6. Grease and install the brake caliper bolt. Use Disc Brake Caliper Slide Grease D7AZ-19590-A (ESA-M1C172-A) or equivalent. Tighten the brake
caliper bolt to 34-39 N-m (25-29 lb ft).
7. Position the parking brake rear cable and conduit into the rear brake operating lever and rear disc support bracket.
8. Install the parking brake rear cable and conduit retaining clip.
9. Adjust the parking brake rear cable and conduit so there is NO clearance between the cable end and the rear brake operating lever.
Rear Brake Operating Lever, Cable And Conduit Adjusting Nut
10. Tighten the parking brake rear cable and conduit adjusting nut.
