Probe V6-153 2.5L DOHC (1994)
Radiator: Service and Repair
WARNING: Allow radiator to cool prior to beginning following procedure. Slowly remove radiator cap to release system pressure. Caution
must be used as system contains scalding hot fluid which when under pressure can blow out of radiator fill neck, causing personal injury.
1. Disconnect battery ground cable.
2. Slowly remove radiator cap, then open drain valve at bottom of radiator and drain system.
3. Remove fresh air duct.
4. Remove upper and lower radiator hoses.
5. Remove radiator overflow hose.
6. Remove coolant expansion tank.
7. Disconnect cooling fan motor and A/C condenser cooling fan motor electrical connectors.
8. On models equipped with automatic transaxle, disconnect transaxle oil cooler lines at radiator and plug hose ends to prevent leakage.
9. Remove radiator mounting brackets.
10. Move air bag electrical wiring harness to allow clearance for radiator removal.
11. Remove radiator, engine cooling fan, and A/C cooling fan from vehicle as an assembly.
12. Reverse procedure to install, noting following:
a. Tighten radiator mounting bracket bolts to 14-18 ft lb.
b. Check and fill cooling system and transaxle fluid levels.
c. Tighten fan shroud bolts to 71-88 in lb.
d. Operate engine until normal engine coolant temperature is reached and check for leaks.
