Probe V6-153 2.5L DOHC (1994)
Seat Belt: Service and Repair
Removal and Installation
Front Safety Belt Buckle
Removal
1. Slide the front seat as far rearward as possible.
2. Remove the front safety belt buckle end anchor bolt.
3. If removing the LH front safety belt buckle end, disconnect the battery ground cable and disconnect the safety belt warning indicator switch under
the driver's seat.
4. Remove the front safety belt buckle end.
Installation
To install, reverse the removal procedure. Tighten the front safety belt buckle end anchor bolt to 38-78 Nm (28-58 lb-ft).
Front Seat Belt Retractor
Removal
1. Disconnect the battery ground cable.
2. Slide the front seat forward.
3. Depress the two clips securing the front of the rear seat cushion and cover to the floor.
4. Route the rear safety belts through the rear seat cushion and cover.
5. Remove the rear seat cushion and cover.
6. Position the rear seat back cover and cushion out of the way.
7. Remove the RH quarter trim panel or LH quarter trim panel.