Probe V6-153 2.5L DOHC (1994)
4. Remove the anchor bolts from the rear safety belt and buckle.
5. Remove the rear safety belt and buckle.
Installation
To install, reverse the removal procedure. Tighten the anchor bolts to 38-78 Nm (28-58 lb-ft).
Rear Seat Belt Retractor
Removal
1. Disconnect the battery ground cable.
2. Slide the front seat forward.
3. Depress the two clips securing the front of the rear seat cushion and cover to the floor.
4. Route the rear safety belts through the rear seat cushion and cover.
5. Remove the rear seat cushion and cover.
6. Position the rear seat back cover and cushion out of the way.
7. Remove the RH luggage compartment side cover or LH luggage compartment side cover.
8. Remove the RH quarter trim panel or LH quarter trim panel.
9. Remove the floor anchor bolt from the rear seat back pivot.
