Probe V6-153 2.5L DOHC (1994)
Fuel Pump Inertia Switch: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the battery ground cable.
2. Roll away the luggage compartment floor cover from the left rear corner.
3. Remove the inertia fuel shutoff switch bracket bolt.
4. Lift the inertia fuel shutoff switch and inertia fuel shutoff switch bracket out of the left rear quarter panel cavity.
5. Disconnect the inertia fuel shutoff switch electrical connector.
6. Disconnect the bolts from the inertia fuel shutoff switch to the inertia fuel cutoff switch bracket.
7. Remove the inertia fuel shutoff switch.
INSTALLATION
To install, reverse the removal procedure.