Probe V6-153 2.5L DOHC (1994)
Window Glass: All Technical Service Bulletins
Front Door Glass - Wind Noise/Water Leaks
Article No.
94-5-4
03/09/94
^
DOOR - FRONT - GLASS CLOSURE ON TOP OF DRIP RAIL
^
GLASS - FRONT DOOR - ADJUSTMENT PROCEDURE
^
LEAKS - WATER - FRONT DOOR GLASS
^
WINDNOISE - FRONT DOOR GLASS
FORD:
1993-94 PROBE
This TSB article is being republished in its entirety to expand on the front door glass adjustment procedure and to include a step for checking door glass
pitch adjustment.
ISSUE:
The 1993/94 Probe Service Manuals do not provide a clear procedure for adjusting the front door glass for windnoise, water leaks, window
stutter/jumping and door-closure-on-top-of-the-drip-rail concerns.
ACTION:
Use the following front door glass adjustment procedure and specifications to correct door glass windnoise, water leaks, window stutter/jumping and
door glass-closure-on-top-of-the-drip-rail concerns.
SPECIFICATIONS
The specifications provided in this TSB article have ranges because individual vehicles may vary based on how the door fits on the car body. It may be
necessary to change the door glass adjustments to the high or low end of the specifications to correct the concern on your vehicle.
FRONT DOOR GLASS ADJUSTMENT PROCEDURE
1.
Check the door and striker for correct adjustment. Repair as necessary. Refer to the 1993 Probe Service Manual, Sections 01-03-5 and 01-14A, for
service details.
2.
Check the door glass for correct adjustment by using the following steps. Complete the steps in the order provided to obtain the best results.
NOTE:
IT IS NOT NECESSARY TO REMOVE THE WINDOW TO PERFORM ANY OF THE FOLLOWING ADJUSTMENTS. HOWEVER, IF FOR
OTHER REASONS THE GLASS NEEDS TO BE REMOVED, DO NOT REMOVE THE WINDOW GUIDE BRACKETS FROM THE
WINDOW. THESE ARE NOT ADJUSTABLE AND ARE VERY DIFFICULT TO REINSTALL PROPERLY.
DOOR PANEL REMOVAL AND INSTALLATION
3.
Remove the door panel if adjustments need to be made. All door glass measurements can be made without removing the door panel.
DOOR TRIM PANEL REMOVAL
