Probe V6-153 2.5L DOHC (1994)
g.
Remove the three (3) remaining door trim panel screws and one (1) retaining clip. See Figure 3.
h.
Carefully pull the door trim panel away from the door to disengage the clips.
i.
Guide the inner door handle trim through the door trim panel.
j.
Remove the door trim panel.
INSTALLATION
To install, reverse the removal procedure. Replace any door clips that have been damaged. Refer to the parts listing for part number information.
NOTE:
THE FOLLOWING STEP SHOULD BE PERFORMED BEFORE ANY OTHER ADJUSTMENT.
4.
Check door glass pitch adjustment:
a.
Measure from the front edge of the regulator channel to the front edge of the glass guide channel, Figure 4. The measurement should be 308
mm (11.82"). To correct, loosen the front glass guide and adjust.
b.
Tighten the glass guide channel and recheck.
