Probe V6-153 2.5L DOHC (1994)
b.
If adjustment is required, lower the window 1" (25.4 mm) and make a reference mark on the door. See Figure 6.
c.
Loosen the glass stop bolt just enough to be able to slide the stop and move the stop the same distance the mark is out of specification.
Example: If the glass is 1.0 mm too high, lower the stop 1.0 mm.
d.
Tighten the glass stop bolt.
e.
Raise the window and recheck.
6.
Check the door glass rear inboard and outboard adjustment. Adjust if necessary.
NOTE:
DO NOT ADJUST THE FRONT WINDOW TRACK INBOARD AND OUTBOARD ADJUSTMENT SCREW.
a.
With the glass in the full up position, close the door until the top rear corner of the glass lightly touches the weatherstrip. See Figure 6.