Probe V6-153 2.5L DOHC (1994)
j.
Remove the door trim panel.
Door Trim Panel Installation
To install, reverse the removal procedure. The door clips must be replaced to prevent door panel squeaks and rattles. Refer to the parts listing for part
number information.
NOTE:
THE FOLLOWING STEPS MUST BE PERFORMED IN THE LISTED SEQUENCE.
3.
Check door glass pitch adjustment:
a.
Check the clearance between the quarter glass and door glass along the B-pillar. The correct gap should be 9-13 mm (0.35-0.51").
b.
If adjustment is required, mark and loosen the top regulator and guide 12 mm nuts (for power windows loosen the three (3) power regulator
10 mm bolts), and reposition the door glass (Figure 5).
c.
Torque the regulator nut to 19-25 N.m (14-18 lb-ft) and, if equipped, the three (3) power regulator bolts to 7-9 N.m (62-80 lb-in).
d.
Check the door glass pitch adjustment by measuring from the front edge of the regulator channel to the front edge of the glass guide channel
(Figure 6). The measurement should be 308 mm (12.13"). To correct, loosen the front glass guide and adjust.
e.
Tighten the glass guide channel and recheck measurement.
f.
Check lower regulator and guide 12 mm nuts for proper torque - 19-25 N.m (14-18 lb-ft).
g.
Recheck the quarter glass-to-door glass gap.
