Probe V6-182 3.0L (1990)
^
92354 Glasurit Clear
100 Parts
^
521-111 Elastifier
20 Parts
^
929-29 Hardener
60 Parts
Apply 2 wet coats with 5 to 10 minutes flash time between coats. Overnight dry or force dry at 140~F for 30 minutes.
CAUTION:
OUR ENVIRONMENT IS PRECIOUS - PLEASE USE PROPER DISPOSAL TECHNIQUES FOR ANY VOLATILE ORGANIC
COMPOUNDS (V.O.C.'s) OR EXCESS MATERIALS.
(E) Lower Body-Side Stone Chip Protection Program
Ford Motor Company has recently initiated a program to provide improved stone-chip protection on some vehicles and to increase the corrosion
protection on cars and trucks.
Some customers are unaware of body side anti-stone chip protection which appears as wavy orange peel texture on the lower body areas.
Ford is increasing the use of PVC (poly vinyl chloride) material which is applied in a thicker coating on the lower body-side. This material has been in
use on vehicles destined for the Canadian market for many years.
This PVC material is now applied at the following plants on ALL vehicles.
^
Edison - Ranger
^
Hermosillo - Escort/Tracer
^
Louisville - Ranger and Explorer
^
Ohio Truck - Econoline
^
Wayne - Escort/Tracer
This process is also planned for Kansas City, Oakville, Twin Cities and Wixom.
This material can be identified by the "orange peel" appearance and a visible "break-line" between protected and unprotected areas in the lower body
areas.
CAUTION: THIS PROTECTION MUST NOT BE REMOVED IF VEHICLE IS EXPECTED TO MAINTAIN THE CORROSION PROTECTION.
Some customers have expressed concerns due to the appearance of the treated areas. These customers did not know about the extra protection this
material provides their vehicle. Once explained, customers were pleased with the added protection and accepted the orange peel finish.
NOTE: DEALERS SHOULD ADVISE THEIR SALES PEOPLE, SERVICE PEOPLE, AND CUSTOMERS, OF THE REASONS AND BENEFITS
OF THIS PROTECTION. CANADIAN DEALERS STRESS THIS AS A SELLING POINT WITH THEIR SALES PEOPLE. IT IS
CONSIDERED A COMPETITIVE ADVANTAGE.
(F) Surface Defect Removal Without Repainting
Exterior paint surface damage or imperfections, where the primer coat does not show through, should be restored without repainting. The restoration of
gloss and luster, after the condition has been repaired, is possible with new techniques and improved materials.
The following procedure is applicable to surface conditions such as dirt particles, orange peel, runs, sags, industrial fallout stains, swirl marks, light
scratches and other minor surface imperfections. For dirt particles or scratches in several localized areas, the entire panel should be refinished to
maintain a uniform appearance.
PREPARATION
To repair the affected surface it must be clean and dry. Mask off adjacent panels, mouldings, stripe and character lines as required.
CAUTION: EYE PROTECTION, AND FACE MASK SHOULD BE WORN. RINGS, BRACELETS, WATCHES AND BELT BUCKLES MUST BE
REMOVED TO PREVENT ACCIDENTAL DAMAGE TO PAINT FINISH.
SERVICE PROCEDURE
1.
Remove sanding marks with rubbing compound.
