Probe V6-182 3.0L (1990)
housing joint.
c.
If no leakage is observed, reassemble the glove compartment and trim panel. Return the vehicle to the owner.
11.
If moisture leakage was observed when the blower was turned to the highest position, proceed as follows:
a.
Remove the air duct band.
b.
Add a piece of duct tape, 6-7, (152-178 mm) long to the lower joint(s) that were leaking, Figure 4.
c.
Reinstall the air duct band.
12.
Install the glove compartment and lower trim panel.
NOTE:
THE "RECIRCULATION" POSITION USES INTERIOR AIR THAT IS DRIER (LESS HUMID) THAN OUTSIDE AIR AND WILL REDUCE
MOISTURE/WATER CONDENSATION BUILD UP INSIDE AND OUTSIDE OF THE BLOWER MOTOR, EVAPORATOR HOUSINGS. THIS
WILL REDUCE CONDENSATION ESPECIALLY IN HIGH HUMIDITY CONDITIONS
OTHER APPLICABLE ARTICLES:
89-16-7, 91-17-3, 91-8-6, 92-2-5
SUPERSEDES:
92-4-5
WARRANTY STATUS:
Eligible Under Basic Warranty Coverage
OPERATION DESCRIPTION
TIME
922003A
Install Metal Air Baffle.
0.5 Hr.
922003B
Repair Drain Tube Blockage
0.4 Hr.
In Vehicle.
922003C
Remove Evaporator, Case
2.7 Hr.
And Repair Drain Tube Hole
Or Replace A/C Evaporator
Core Tube Seal.
DEALER CODING
BASIC PART NO.
CONDITION CODE
19858
55
OASIS CODES:
208000, 208999
