Probe V6-182 3.0L (1990)
5.
Road test vehicle again, following the procedures and warnings as stated in steps 2 and 3. If the drift condition is still seven (7) seconds or less
proceed to step 6.
6.
Refer to Section 04-00, pages 7-9 for a description of Caster, Camber, Toe-in, and adjustment procedures.
NOTE:
SET FRONT TOE-IN TO "O" EACH WHEEL AND REAR TOE-IN AT 1.5 MM EACH WHEEL.
Figure 3
Figure 4
7.
Inspect the upper strut mountings for the position of the paint marks on the rubber insulator. It is visible at the strut attachment. Refer to Figures 3
and 4.
a.
If the vehicle drifts left rotate the upper struts to the following positions:
^
Left strut mount to position number 2.
^
Right strut mount to position number 3.
^
Adjust toe-in to the setting listed in step 6.
b.
If the vehicle drifts right rotate the upper struts to the following positions:
^
Left strut mount to position number 3.
^
Right strut mount to position number 2.
