Probe V6-182 3.0L (1990)
5. Remove the cotter pin and the tie rod end attaching nut.
6. Separate the tie rod end from the steering knuckle arm using Tie Rod End Separator TS5M-3395-A. If the tie rod end does not separate easily,
give the steering knuckle a sharp blow with a soft faced hammer to shock the taper.
7. Remove the caliper and anchor bracket assembly. Hang the caliper on a hook so it does not hang from the brake hose.
8. Remove the rotor.
Remove Ball Joint Clamp Bolt And Nut.
9. Remove the lower control arm ball joint clamp bolt and nut.
Separating Ball Joint.
10. Pry downward on the lower control arm to separate the ball joint from the steering knuckle.
Removing Steering Knuckle.
