Probe V6-182 3.0L (1990)
11. Remove the steering knuckle to strut attaching bolts.
12. Slide the front hub/steering knuckle assembly out of its bracket in the strut and off the end of the halfshaft. Use care to prevent damage to the
grease seals.
Removing Hub.
NOTE: If the wheel hub binds on the halfshaft splines, it can be loosened by lightly tapping with a plastic faced hammer on the end of the halfshaft.
CAUTION: Never use any type of metal faced hammer to separate the halfshaft from the wheel hub. Damage to the CV joint - internal
components will result. If the halfshaft splines become rusted to the hub, a two-jaw puller such as D8OL-1002-L or hub puller must be used to
separate them.
INSTALLATION
Removing Hub.
1. Position the front hub/steering knuckle assembly over the halfshaft and into the strut.
