Probe V6-182 3.0L (1990)
a.
Make sure the air conditioning pipe from the compressor to the condenser is not interfering with the radiator, Figure 2. If necessary reposition
the A/C pipe to attain enough clearance between the A/C pipe and radiator.
b.
Make sure the cooling fan is not contributing to the idle vibration.
^
Turn the A/C system on.
^
Confirm that the compressor clutch and cooling fan are operating.
^
Inspect the cooling fan mounts for proper position and bolt torque.
6.
Adjust the hood lock if a "rattling" noise comes from the hood. Refer to the 1989 Probe Shop Manual, page 44-08-01 for service details.
Figure 3
7.
Replace the Number 1 & 2 engine mounts with new ones, Figure 3.
Figure 4
8.
Remove and throw away the Number 2 silencer hangers and rubbers which are located in front of the presilencer, Figure 4. After removing the
hangers from the body, put the bolts back to the body to prevent water from entering.
9.
Inspect the upper radiator hose clamp tips. If the tips are straight up, rotate the clamp 90~ to the left.
OTHER APPLICABLE ARTICLES: None
