Probe V6-182 3.0L (1990)
16.
Using a small flat-bladed screwdriver, lift locking tab. See Figure 9.
17.
Separate rail from locking tab.
NOTE:
Place cable assembly on clean workbench to prevent contamination of lubricating grease on cable.
18.
Pull cable and buckle carrier from rail.
Installation
1.
Place new rail on bench with outboard side facing up.
2.
Install buckle carrier onto cable. See Figure 10.
3.
Install cable assembly into new rail. Make sure the red release button on the buckle carrier is facing upward. Align cable guide with rail (cable will
only go into rail with guide in the correct position).
4.
Slide buckle carrier forward until locking tab engages rail.
