Probe V6-182 3.0L (1990)
2.
Locate and access the inertia switch. See Figure 1.
3.
Check for water leaks in the area.
a.
Identify the source of any water leaks.
b.
Seal the area as required.
4.
Remove the inertia switch.
a.
Remove the affected bolts.
b.
Disconnect the electrical connector from the switch.
c.
Remove the inertia switch from the mounting bracket.
5.
Install a new inertia switch on the mounting bracket.
6.
Depress the red button on the top of the switch. See Figure 2.
