Probe V6-182 3.0L (1990)
13. Remove the motor and track assembly.
INSTALLATION
1. Position the motor and track assembly and install the three upper track mounting bolts. Tighten the bolts to 38-78 Nm (28-58 ft lbs).
2. Install the upper track mounting screw.
3. Install the two side track mounting bolts. Tighten the bolts to 38-78 Nm (28-58 ft lbs).
4. Install the four cable retaining cap screws.
5. Install the three motor mounting bolts. Tighten the bolts to 38-78 Nm (28-58 ft lbs).
6. Connect the front limit switch electrical connector.
7. Install the quarter trim panel.
8. Install the 'A-B' pillar trim panel.
9. Buckle the shoulder belt to the carrier.
10. Connect the negative battery cable.
11. Check the passive restraint system for proper operation.
