Probe V6-182 3.0L (1990)
7.
Coil and tie-strap the jumper harness to the vehicle wiring harness. See Figure 3.
8.
Install pad and rear seat cushion. Ensure latches are properly engaged.
9.
Connect battery negative cable and close hood.
10.
Disconnect Rotunda Memory Saver.
11.
Verify engine operation.
Attachment III-B - Technical Instructions - 1993-95 Probe
Fuel Pump/Sender Jumper Wire Modification Instructions
ORDER PARTS AS REQUIRED
ENGINEERING PART NUMBER
DESCRIPTION
QUANTITY
F52Z-14408-AA
Jumper Harness
1
95874-S
Tie Strap
1
Affected Vehicles:
All 1993, 1994 and 1995 Probe built through April 14, 1995
Technical Instructions
1.
Connect Rotunda Memory Saver 014-R1064 to retain memory in radio settings, engine learn strategies, etc.
2.
Open hood and disconnect battery negative cable.
3.
Open liftgate. Fold rear seat back forward.
4.
Remove cargo net and package tray, if equipped.
5.
Remove cargo net fasteners, if equipped, or the two (2) upper screws holding the luggage compartment rear cover.
6.
Unscrew the two (2) lower luggage compartment rear cover fasteners.
7.
Remove the two (2) push pins on either side of the luggage compartment rear cover, then remove cover from vehicle.
8.
Remove five (5) pushpins from around left luggage compartment side cover.