Probe V6-182 3.0L (1990)
8. Check the bearing end play.
a. Make sure the parking brake is fully released.
b. Rotate the brake drum to make sure there is no brake drag.
c. Using a dial indicator, D78P-4201-B or equivalent, check the wheel bearing end play. End play should not exceed 0.2mm (0.008 inch)
d. If end play exceeds specifications, replace wheel bearing.
9. Stake the attaching nut using a cold chisel with the cutting edge rounded as shown.
CAUTION: If the nut splits or cracks after staking, it must be replaced with a new nut.
10. Install grease cap.
11. Install wheel and tire assembly.